Pack Building

Potting Compound for Battery Packs

Protect BMS boards from moisture and vibration

By Arambhika · · 5 min read

Two-Part Silicone Potting Compound (1:1, Thermally Conductive Gel)
Featured product: Two-Part Silicone Potting Compound (1:1, Thermally Conductive Gel)

Packs for scooters, rickshaws and outdoor lighting face water, dust and vibration. Potting fills the space around electronics with a flexible compound so those things cannot get in.

What potting does

A potting compound is poured over a board or connection and cures into a protective block. It keeps out moisture and dust, holds components against vibration and can help move heat away from parts that warm up. A silicone gel stays soft, so it protects without stressing the parts.

The product

Our two-part silicone potting compound is a thermally conductive gel with a 1:1 mix ratio. Mixing equal parts makes it easy to measure. It is sold per kg.

How to use it

  1. Clean and dry the board and housing. Remove dust and flux.
  2. Mix the two parts in the ratio on the pack label, stirring slowly to avoid air bubbles.
  3. Pour into the housing and let it settle. Tap gently to release trapped air.
  4. Allow the full cure time on the datasheet before handling or powering up.

Test on a spare board first. Potted parts are hard to repair, so keep test points and any parts you may need to replace out of the pour.

Where it makes sense

Potting is not a substitute for a good enclosure. Use it with a sealed case and sound wiring, and with a smart BMS you can still monitor over Bluetooth.

General guidance only. Check cell, BMS and strip datasheets and the standards that apply to your product before you build or sell a pack.

Products in this guide

Two-part silicone potting compound

Live stock and price from our store. Tap a product to add it to your quote.

Loading products…

View the full product store →

Frequently asked questions

What does 1:1 mean on potting compound?

It means the two parts are mixed in equal amounts. Check the datasheet to see whether that is by weight or by volume.

Can I remove potted electronics later?

Silicone gel is easier to cut away than rigid epoxy, but repair is still difficult. Plan accordingly.

Is potting required by law?

Requirements depend on your product and its standards. Check them for your pack type before deciding.

See all FAQs →