BMS Guide

LFP vs NMC BMS: Pick the Series Count

From 4S to 30S, matched to your voltage

By Arambhika · · 5 min read

DALY LFP 15S-100AMP SMART BMS
Featured product: DALY LFP 15S-100AMP SMART BMS

A BMS is built for one chemistry and one series count. Buy the wrong one and it will either refuse to work or protect at the wrong voltages. This guide turns your target pack voltage into the right "S" number.

Start from the cell voltage

An LFP cell is about 3.2 V nominal and an NMC cell about 3.6 V nominal. Multiply by the number of cells in series (the "S" count) to get the pack voltage. The BMS must match both the chemistry and that count.

Common combinations

PackLFPNMC
12 V class4S (12.8 V)3S or 4S
24 V class8S (25.6 V)7S
48 V class15S (48 V) or 16S (51.2 V)13S (46.8 V)
72 V class23S (73.6 V)20S (72 V)
96 V class30S (96 V)-

Examples from the store

Do not mix chemistries

An LFP BMS charges to a lower cut-off than an NMC BMS. Using an NMC board on LFP cells leaves charge unused, and an LFP board on NMC cells over-charges them, which is unsafe. Always buy the board that names your chemistry. For the full build steps see our 48V scooter pack guide.

General guidance only. Check cell, BMS and strip datasheets and the standards that apply to your product before you build or sell a pack.

Products in this guide

Daly LFP and NMC BMS by series count

Live stock and price from our store. Tap a product to add it to your quote.

Loading products…

View the full product store →

Frequently asked questions

How many cells in series for a 48V LFP pack?

Most 48 V LFP packs use 15S (about 48 V nominal) or 16S (about 51.2 V nominal). Check what your charger and controller are designed for.

Can I use a 16S BMS on a 15S pack?

No. The BMS monitors each series group, so the cell count has to match the board.

Is 13S NMC the same as 48V?

A 13S NMC pack is about 46.8 V nominal and is sold as a 48 V pack. Fully charged it sits near 54.6 V.

See all FAQs →